Genuine RK Sport Hood! Made in the USA! By one of the very best in the business!
Here
at Brody Dog Auto, we do not sell cheap low end hoods! Or headaches
you could call them! Over the years we have dealt with many
manufactures & weeded out the bad ones. We have seen and heard it
all. Nobody likes a headache & were not going to sell you one!
Form
and function are perfectly blended in this fiberglass Ram Air Hood. The
sporty lines and assertive look of the center scoop give the F-150 a
distinctive look while the functionality of the scoop allows cool air to
be channeled into the engine compartment just over the factory air box.
Heat extraction venting on this one is at the rear cowl area and helps
hot engine air to vent. Cool air is more dense and burns more
efficiently than hot air and can improve both power and efficiency.
All RK Sport Award Winning hoods are hand laid fiberglass and use stock hardware for easy of installation.
- Replace your stock hood with a more stylish functional ram air hood.
- Besides the added cool looks, they have cool function in directing outside air to your air filter increasing performance!
- This hood has functional ram air ducting built in with functional
heat extractor vent at rear of cowl. (INCLUDES MESH GRILLE FOR HOOD)
It is constructed from hand-laid fiberglass and high quality "ISO" resin.
Installs using stock hardware. Comes Gel Coated Gray ready to prep, prime and paint.
Made in USA Material: Fiberglass. Uses OEM hardware and Struts
Each hood comes with a one year warranty.
HOOD CONSTRUCTION:
Many
of our ram air hoods are constructed of hand-laid fiberglass, using
high quality "ISO resin" to give you the best possible quality in a
fiberglass hood. It comes with a smooth gel-coat finish, on both top and
underside surfaces.
All hinge and latch
mountings are reinforced with steel plates. All bolt holes are
pre-drilled and tapped for easy installation. To install these hoods,
all you need to do is transfer your stock hardware onto it and bolt it
on to the factory hinges for final alignment.
ISO resins are a higher quality, low shrink resin that allows the part to withstand more heat and prevent distortion.
SHIPPING INFORMATION:
-All hoods are built to order
-FREE Shipping to all lower 48 states
-Please allow approximately 10 business days before your hood ships
Frequently Asked Questions:
Q 1: Will water get into my intake with your ram air hood?
A.
Our hoods have a built-in water management system to prevent water from
getting in. To date, we have not had a complaint of water getting into
an intake.
Q 2: What should I do if your product comes damaged?
A.
Even though we package our products very well, occasionally the freight
carrier will damage our product. In that case, refuse the shipment and
do not sign for it. It is expressly recommended that the package be
opened and inspected immediately upon receipt, even if the box looks
undamaged.
CAUTION!!! If you sign off
with the freight carrier on a damaged product, they will not honor any
freight damage claim at a later date and you will be held responsible.
CAUTION!!!
If you are having someone besides yourself receiving your package you
must make it clear to them that they are not to sign off with the
freight carrier until they have inspected the product and found it to be
ok. If you have to refuse our product because it was damaged, simply
call us and we will send you out another one ASAP. If you or someone
else signs off on a damaged product, we will not be held responsible.
You must refuse it!
Q 3: Should I prefit your products before I have them painted?
A.
Yes, it is highly recommended that any hood be prefit before it is
painted. This is especially true with fiberglass parts. If you are not
the original owner it is possible that the vehicle was in a previous
accident, which could effect how our product fits you vehicle. Even new
vehicles are not all assembled exactly the same. Sometimes you have to
readjust your fenders and do other minor adjustments to make everything
right.
horrible experience 
