Genuine RK Sport Hood! Made in the USA! By one of the very best in the business!
Here
at Brody Dog Auto, we do not sell cheap low end hoods! Or headaches
you could call them! Over the years we have dealt with many
manufactures & weeded out the bad ones. We have seen and heard it
all. Nobody likes a headache & were not going to sell you one!
Form
and function are perfectly blended in this fiberglass Ram Air Hood. The
sporty lines and assertive look of the center scoop give the F-150 a
distinctive look while the functionality of the scoop allows cool air to
be channeled into the engine compartment just over the factory air box.
Heat extraction vents look cool and aid in helping hot engine air vent.
Cool air is more dense and burns more efficiently than hot air and can
improve both power and efficiency.
** Dealerships,clubs,organizations: We can ship additional hoods for no extra freight cost if shipped together.
All RK Sport Award Winning hoods are hand laid fiberglass and use stock hardware for easy of installation.
- Replace your stock hood with a more stylish functional ram air hood.
- Besides the added cool looks, they have cool function in directing outside air to your air filter increasing performance!
- This hood has functional ram air ducting built in with functional
heat extractor vents/gills. (INCLUDES MESH GRILLE FOR HOOD)
Hood underside showing cut out for the functional ram air and vent for the side heat extractors.
It is constructed from hand-laid fiberglass and high quality "ISO" resin.
Installs using stock hardware. Comes Gel Coated Gray ready to prep, prime and paint.
Made in USA Material: Fiberglass. Uses OEM hardware and Struts
Each hood comes with a one year warranty.
HOOD CONSTRUCTION;
Many
of our ram air hoods are constructed of hand-laid fiberglass, using
high quality "ISO resin" to give you the best possible quality in a
fiberglass hood. It comes with a smooth gel-coat finish, on both top and
underside surfaces.
All hinge and latch
mountings are reinforced with steel plates. All bolt holes are
pre-drilled and tapped for easy installation. To install these hoods,
all you need to do is transfer your stock hardware onto it and bolt it
on to the factory hinges for final alignment.
ISO resins are a higher quality, low shrink resin that allows the part to withstand more heat and prevent distortion.